Console House 10 Mode Betriebsanleitung PDF herunterladen (Seite 80)

automation in an Omni system. Each program must specify when that

program should execute and an action to be taken. The program may

also specify a condition that must be true for the program to execute.

Each program can be set up to execute at a certain time of day or on

the occurrence of a particular event in the system. When this time or

event occurs, the programmed action will be taken if, and only if, the

specified condition is also true at that time.

The Program menu allows you to add, review, change, and delete

automation programs. To enter the Program menu, from the Setup

menu, press the 3 (PROG) key.

SET UP PROGRAMS

1=ADD 2=SHOW 3=DELETE

The 1 (ADD) key is used to add new automation programs to the

system. When you press the 1 (ADD) key, the Edit Program menu is

displayed which allows the various parts of a program to be specified -

See Edit Program. You may edit each part of the program as specified

under Edit Program. Press the ' # ' key at the Edit Program

menu to show the newly entered program. Press the ' # ' key again to

save the program, or press the ' * ' key to return to the Edit Program

menu to cancel entry of the new program and return to the Set Up

Programs menu.

Once the new program is entered, the display will return to the Set Up

Programs menu.

The 2 (SHOW) key is used to review, edit, and delete existing

programs. From the Set Up Program menu, press the 2 (SHOW) key.

The display prompts you to specify which program to be reviewed.

1=CTRL 2=SEC 3=BTTN

4=ALL 5=TEMP #=EVERY

Menu 1 - Programs for a particular control unit number

Menu 2 - All Security related programs

Menu 3 - Programs for a particular macro button

1 = Add Programs

2 = Show Programs

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 135 136

Keine Kommentare

Console House 10 Mode Betriebsanleitung Seite 80