Console House 10 Mode Betriebsanleitung PDF herunterladen (Seite 76)

SETUP

The Setup menu is used to configure operating parameters, program

your system to do its automated control and security functions, and

give descriptions (names) for all of your zones, units, buttons, and

codes. To enter the Setup menu, from the top-level display or from the

main menu, press the 8 (SETUP) key on the console keypad.

Upon entry to the Setup Mode, you will first be prompted to enter a

security code:

SET UP

ENTER CODE:

A Master or Installer Code is required to enter the Setup mode.

SET UP

1=CODES 2=TIME 3=PROG

↓

4=DIAL 5=ARM 6=MISC

7=NAMES 8=VOICE

↑

There are 16 user codes that you may assign to users of the system.

All Omni security codes are 4 digits in length (0001 to 9999). Each

user should be assigned a security code with an authority level, areas

that can be accessed (if area arming is being used), and times in which

the code will be valid. To set up a code, from the Setup menu, press

the 1 (CODES) key. Use the arrow keys to scroll through the codes.

The first item is Code 1. User Code 1 is always set to a Master code.

The only setup option allowed for User Code 1 is to change the code

number.

The existing code number is not shown on the display. To change the

code, enter a four digit number, then press the ' # ' key. Enter 0000 to

disable the code.

Set Up Codes

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 135 136

Keine Kommentare

Console House 10 Mode Betriebsanleitung Seite 76