Console House 10 Mode Betriebsanleitung PDF herunterladen (Seite 21)

(See Duress Code for a description of when to use.)

In the event that you enter your duress code, or a zone configured as a

Duress zone is tripped, the system performs a silent dial out as follows:

- No alarms, lights or console beepers are activated. The system does

not display the duress alarm.

- The system waits the dial out delay, then begins to dial out.

If you are having your system monitored by a central station, the

central station will be sent a code representing the type of alarm

(duress).

The alarm system will reset itself after the outside siren has been on

for 1-30 minutes. When the alarm system resets, any zone that is

ready is reactivated, so the alarm system will be activated again if the

zone is tripped. If a zone remains not ready (i.e. a door has been left

open) it will be automatically bypassed when the alarm resets.

The console will display, "(FIRE, BURGLAR, or EMERGENCY)

ALARM RESET" when this happens. The Flash For Alarm lights will

continue to flash. The dialer will continue to dial until all numbers

have been dialed.

At any time, you can silence your alarm system by pressing the OFF

key and entering your code. If the system has reported, or is in the

process of reporting an alarm to a central station, it will send the

alarm code followed by a code indicating that the alarm has been

canceled by the user.

If an alarm is canceled before the dial out delay has expired, the

system will not report any alarm.

If an alarm is canceled during a voice dial out, the system hangs up

immediately, unless the recipient of the call has entered a master or

access code.

Duress Code

Entered or

Duress Alarm

Activated

Alarm Reset

Alarm Cancel

Home Automation, Inc. 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 135 136

Keine Kommentare

Console House 10 Mode Betriebsanleitung Seite 21