Console House 10 Mode Betriebsanleitung PDF herunterladen (Seite 45)

setback temperature 65 degrees and the Cool setback temperature 80

degrees when the alarm system is put in the AWAY mode. Another

program can turn the energy saver(s) off (to resume normal operation

of the HVAC system) at 4:30 P.M. on weekdays to make the house

comfortable before arriving home. Different setback temperatures

could be set for the NIGHT mode.

To set up your thermostat for use with the energy saver, set it in the

appropriate mode (Heat, Cool, or Auto, if available) and set the

temperature to your preference.

NOTE: Your heating and cooling system will always be off if you set

your thermostat to Off mode. The PESM cannot turn it back on. The

PESM cannot make your system cool below the thermostat's cool

setting, or heat above the thermostats heat setting.

Control actions for temperature sensors:

Set low setpoint

Set high setpoint

To enter the temperature menu, from the top-level display or from the

main menu, press the 5 (TEMP) key on the console keypad. You will

be prompted with the first named temperature zone (i.e. Upstairs).

The temperature zone can be specified by entering the temperature

zone number followed by the ' # ' key, or by pressing the arrow keys to

scroll through the list of temperature zones. Press the ' # ' key when

the desired temperature zone is shown.

TEMPERATURE ZONE:

ENTER TEMPERATURE ZONE

↓

After the ' # ' key is pressed, a menu appropriate for the type of

temperature zone is shown.

For Programmable Energy Saver Modules:

Upstairs

0=OFF 1=ON 2=HEAT

↓

Upstairs

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 135 136

Keine Kommentare

Console House 10 Mode Betriebsanleitung Seite 45