Console House 10 Mode Betriebsanleitung PDF herunterladen (Seite 110)

To enter a voice description, enter the one, two, or three digit code

shown in Table 2 in the Appendix C for each description (word or

group of words), then press the ' # ' key. After you have entered the

complete description for each item (unit, zone, button, code, tempera-

ture, and area), press the ' # ' key twice. You may enter up to four

descriptions (word or group of words) for each unit, zone, button,

code, and area.

UNIT 1 VOICE:

↓

UNIT 1 VOICE:

144 109

↓

When Unit 1 is spoken over the phone, the Omni will say, "UNIT 1 -

PORCH LIGHT".

The final setup item is accomplished over the telephone. This is the

address that the system says when it dials out in an emergency. Your

voice will be recorded on computer chips in the Omni controller and

saved to be played back in the emergency message when the system

dials out for an alarm.

Pick up an inside phone and press the ' # ' key on the telephone within

3 seconds of picking up the phone.

The Omni will respond with a menu. Press 8 on the telephone keypad,

then 8.

The unit will say "ADDRESS IS:" then the Omni will play back the

message stored in the Address memory if one has been entered by your

installer.

To record your address, Press 9, then enter the Master Code.

The Omni will say "RECORD ADDRESS", then BEEP.

In a normal tone of voice, say your name and address and any helpful

information for locating your house.

Set Up Address

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 135 136

Keine Kommentare

Console House 10 Mode Betriebsanleitung Seite 110